Bond-ACE G88 is a special formulated homopolymer agent. It has a special plasticiser agent added for improving bonding strength of various subtrates suitable for all cementitious products.
Bond-Ace G88 can be used for interior and exterior. Concrete structures, renders and all cementitious products. To new and old cement plastered surfaces. To cemboard, wood, metal, ceramic/porcelain tiles, concrete, brick and marble surfaces. Tile to tile: marble to marble or granite to granite... etc.
Surface preparation - The surface must be structurally sound and clean, free of oil, greese, wax, dust, sand, dirt, laitance, paints, efflorescence, curing compounds and loose materials of any type. If the surface is questionable, apply a small test patch of Bond-ACE G88. Allow to completely dry and observe for any signs of lifting, wrinkling, peeling or curling. If these occur, additional surface preparation is recommended.
Recommended cleaning methods are by high-pressure water jets.
Bond-ACE G88 can be applied with paint roller or paint brush or spraying.
Open the original packing and use as it is, do not dilute with water or solvent. Do not add any admixture.
Do not use over water soluble materials such as glue, calcimine, wall paper, casein-based adhesive or where constant moisture is present.
Never shake and box mix as to entrap air bubbles.
Apply Bond-ACE G88 to the treated surfaces evenly. Thin continuous unbroken film is recommended.
Allow Bond-Crete G88 to dry Approximate 30 minutes of drying time, subsequent activities can be carried out. (eg: plastering or tiling) Susequent application of plastering, Skim coating and cement mortar for tilling shall be performed within 72 hours provided Bond-ACE G88 condition is clean, dust free, uncontaminated and intact.
Do not apply to wet surfaces or surfaces where there may be hydrostatic pressure such as retaining walls and swimming pool.
Do not apply to frozen or frost covered surfaces or when temperature is below 50℃ (10℃) is expected to be within 12 hours.
|Packaging||20 Litres / Pail|
|Application Method||Bond-ACE G88 can be applied with paint roller or paint brush or spraying.|
|Coverage||Approximately 8m2 - 9m2 / litre depending on the method application, temperatures, porosity and texture of the substrate/ surface.|
|Drying Time||Approximately 30 minutes after applied, depending on the temperature and humidity (18℃ - 45℃).|
|Open Time||3 Days.|
|Fire Hazard||Non-flammable, VOC compliant.|
|Shelf Life||12 Months.|
|Storage||Store in protected areas where ambient temperature is between 50℉ - 90℉ (10℃ - 37℃).|